Torque management

General Chat Developer Questions
1

Hello

My question maybe asked in the forum, but I don’t found it right now
Will there be the possibility to manage the amount of torque in the game
For example I say that I will a maximum torque of 320nm. If I build my engine normally, I become a little peak of 320nm in a small rev range. If I can use torque management i build the engine with a lot higher maximum torque and cut all over 320nm, so I become a 320nm plate over a great rev range. Also this could be used to save drivetrain.
I think this management is used for example in VW Tsi Engines.
Thank you in advance for an answer
With kind regards

2

We have discussed this and didn’t find a good way of implementing it into the engine designer, but we’ll have a look at it again for the car designer.

3

so its a possible addition then?

4

… :open_mouth:

Read Robert’s (Killrob’s) post, it’s all in there…

5

silly me

6

Juno, stop spamming. Even I am losing my patience.

7

The next post as pointlessly spammy as this gets you a one week ban, I’m tired of these posts reiterating what has already been said better in the posts above, stop it…

8

got it boss